Loading
Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!

water faucet perlator

by Tupni, published

water faucet perlator by Tupni Feb 27, 2013

Description

Spare part for water faucet. Fits 20mm kitchen and bathroom water faucet.

Recent Comments

view all
I made one, (using Cura, and with no top or bottom layer at 0.05 mm layer height, 40% fill).

It works, kinda, but I think a "true" perlator should mix air into the water. This is more like a fine filter. So, it works, but only to concentrate the water flow, not introduce air into it.

Nice trick using the fill setting like that, btw.
Er også Dansk. Problemet er ikke kun PLA'en, men det faktum at det ligger lag på lag. Det giver grobund for bakterier i langt højere grad end hvis den var støbt. Desuden kommer den også i kontakt med hvad selve ekstruderhovedet er lavet af og diverse brandhæmmende materialer. Jeg tror ærligt talt det er OK at bruge, men jeg ville ikke personligt gøre det :)
I grew up in Denmark, and all my LEGO has bite marks. As it was before it "was" toxic. No joking aside, I have of course used a natural PLA.The problem of large rough surface is also in the original, now I just do not descale but can print new significantly cheaper than the købede the original.

More from Household

view more

Liked By

view all

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

This part is made in Sketchup times x10 and ned to be printed at: Scale 10%, 1 perimether, 0 layer top/bottom, Honeycomb infill 0,40 increse infill to save wather ;)

I made one, (using Cura, and with no top or bottom layer at 0.05 mm layer height, 40% fill).

It works, kinda, but I think a "true" perlator should mix air into the water. This is more like a fine filter. So, it works, but only to concentrate the water flow, not introduce air into it.

Nice trick using the fill setting like that, btw.
Be careful about using PLA/ABS for food/water. ABS is unsafe and PLA should be foodsafe apart from the irregularities that may catch bacteria. :)
I grew up in Denmark, and all my LEGO has bite marks. As it was before it "was" toxic. No joking aside, I have of course used a natural PLA.The problem of large rough surface is also in the original, now I just do not descale but can print new significantly cheaper than the købede the original.
Er også Dansk. Problemet er ikke kun PLA'en, men det faktum at det ligger lag på lag. Det giver grobund for bakterier i langt højere grad end hvis den var støbt. Desuden kommer den også i kontakt med hvad selve ekstruderhovedet er lavet af og diverse brandhæmmende materialer. Jeg tror ærligt talt det er OK at bruge, men jeg ville ikke personligt gøre det :)
Top