Rep2 Spool Holder with Support Leg
0
Likes
56
Downloads
254
Views
Published on February 28, 2013
Description
I wanted to get away from a cantilever for the heavier spools. This spool has a fold-away leg. It will fit any spool with hole 30 mm or larger and up to width 100 mm.
Instructions
1. Print it with 4 layers, 15% infill, supports, no rafts.
2. Clean out supports (I used a 1/4" drill for the shaft hollow).
2. Clean out supports (I used a 1/4" drill for the shaft hollow).
License
Rep2 Spool Holder with Support Leg by Clyde is licensed under the Attribution - Share Alike - Creative Commons license.
More from Clyde
More from 3D Printer Accessories
You must be logged in to post a comment.