LED Stripe Fix for ORCA 0.43
1
Likes
50
Downloads
278
Views
Published on February 28, 2013
Description
I thought about to lighten the printbed of my ORCA. I found some LED stripes, but how to fix them? Therefor I build some fixings for the upper rods. I made them 10 cm long and you can chain it.
Instructions
Print six of them for your ORCA 0.43. Fix them with cable ties to the uppest threaded bars, three each side. Fix the LED stripe with the adhesive foil to it. I used 12v LED stripes and connect it directly to the 12V power of the Gen 6 Board. Adjust it as you like, and enjoy the iluminated printbed!
License
LED Stripe Fix for ORCA 0.43 by JackT is licensed under the Attribution - Share Alike - Creative Commons license.
More from JackT
More from 3D Printer Parts
You must be logged in to post a comment.