Simple Cardboard Wine Rack v1
8
Likes
663
Downloads
766
Views
Published on January 13, 2011
Description
This is my second lasercut project, after a few shadowpuppets I produced.
A cardboard wine rack. Holes are 3.5" in diameter -- too small for Magnums, but about right for a standard 750mL bottle. As an added bonus, a variety of stars and coasters are cut out of the waste cardboard.
Inspired by robyward's Assymetric Wine Rack thingiverse.com/thing:4965 -- but I modified the design to fit the limitations of my 12x24 build materials.
TODO for version 2:
- make the holes bigger. 3.6" would allow some larger bottles to fit.
- ditch the side holes, they aren't secure enough for bottles.
- make the struts wider.
A cardboard wine rack. Holes are 3.5" in diameter -- too small for Magnums, but about right for a standard 750mL bottle. As an added bonus, a variety of stars and coasters are cut out of the waste cardboard.
Inspired by robyward's Assymetric Wine Rack thingiverse.com/thing:4965 -- but I modified the design to fit the limitations of my 12x24 build materials.
TODO for version 2:
- make the holes bigger. 3.6" would allow some larger bottles to fit.
- ditch the side holes, they aren't secure enough for bottles.
- make the struts wider.
Instructions
Lasercut 6 copies of this image out of thick (1/4"-ish) cardboard, each 12"x24". Each copy produces one upright part and two connector struts. Assemble.
License
More from jmne
You must be logged in to post a comment.