BIG Ultimaker Feet
5
Likes
159
Downloads
501
Views
Published on March 1, 2013
Derived from
Ultimaker Strong Foot + Damper
by Masonface
Description
I wanted really sturdy feet for my Ultimaker. These feet feature a large (about 5 x 5 cm) stand, cable duct, and holes to screw them in place.
This thing is loosely based on "Ultimaker Strong Foot + Damper" by Masonface (thing ID 25351).
This thing is loosely based on "Ultimaker Strong Foot + Damper" by Masonface (thing ID 25351).
Instructions
Print in ABS or PLA. 0.1 or 0.2 mm perimeter height (I print everything in 0.1). About 20 to 30 % infill. I recommend a hexagonal infill pattern. No support required.
You need 4 of these, of course! ;-)
If you wish to have these noise reductive you can apply some adhesive rubber foil onto the ground of the object. Although there is a half of a sphere cut into the bottom (to reduce the volume and therefore the material needed) the bottom surface is still big enough for that.
Update 2013-03-02: I've attached a print file that contains all four feet in once.
You need 4 of these, of course! ;-)
If you wish to have these noise reductive you can apply some adhesive rubber foil onto the ground of the object. Although there is a half of a sphere cut into the bottom (to reduce the volume and therefore the material needed) the bottom surface is still big enough for that.
Update 2013-03-02: I've attached a print file that contains all four feet in once.
License
BIG Ultimaker Feet by thingster is licensed under the Attribution - Share Alike - Creative Commons license.
More from thingster
More from 3D Printer Accessories
You must be logged in to post a comment.