Flexy Jingly Bracelet
23
Likes
318
Downloads
1114
Views
Published on March 2, 2013
This thing can be customized with MakerBot Customizer!
Open in Customizer
Description
A flexible, tactile, customisable bracelet which makes a pleasant jingly, rattly noise.
The bracelet is made from a number of interlocking segments made from concentric cylinders. One openable segment can be included to allow the bracelet to be fastened when on the wrist so you don't need to oversize it to go over your hand.
The bracelet is made from a number of interlocking segments made from concentric cylinders. One openable segment can be included to allow the bracelet to be fastened when on the wrist so you don't need to oversize it to go over your hand.
Instructions
Open in customiser and play.
The main customisable features are the diameter of the wrist and the height and diameter of the cylinders forming the segments. However there are many other parameters that can be tweaked including wall width, gap between segments (useful if on the first try the inner and outer cylinders stick together), number of struts and whether or not to include an opening segment.
It should print well, but I had some trouble slicing with Cura - worked fine with Kisslicer.
The main customisable features are the diameter of the wrist and the height and diameter of the cylinders forming the segments. However there are many other parameters that can be tweaked including wall width, gap between segments (useful if on the first try the inner and outer cylinders stick together), number of struts and whether or not to include an opening segment.
It should print well, but I had some trouble slicing with Cura - worked fine with Kisslicer.
License
Flexy Jingly Bracelet by PaulM is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.