Y-Carriage contra 3d-plexi-printer
by steijlen, published
This is my Y-Carriage (with no Motor) to be used in my new to develop 3d-plexi-printer.
It can hold two linear bearings (16mm-diameter x 8mm-inside x 24mm-length)
It can hold two bearings (16mm x 5mm x 5mm) for a pulley.
It can hold an optical end stop.
You need the other Y-Carriage (with Motor) on the opposite side of the printer.
It is made for 8mm steel rods and T2.5 timing belt.
Just examine the file to see if you can use it.
For any questions please contact me.
Print with a filling of 30%.
It's designed to print without support.
Liked ByView All
Give a Shout Out
Y-Carriage contra 3d-plexi-printer by steijlen is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving steijlen a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure steijlen would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).