by steijlen, published
This is my X-Carriage (for the extruder) to be used in my new to develop 3d-plexi-printer.
It can hold a NEMA 17 motor and extruder.
It has a piece to act with an optical end stop.
It is made for 8mm steel rods and T2.5 timing belt.
It holds 4 linear bearings (24mm length x 16mm diameter x 8mm inside).
Just examine the file to see if you can use it.
For any questions please contact me.
Liked Byview all
Give a Shout Out
Print with a filling of 30%. Print with support in ABS (it's a bit more flexible that way for the linear bearings)