Gas Can Part
by RJR, published
Use This Project
Give a Shout Out
Replacement neck for plastic gas can.
There are two sizes - small has a 1.3" outside diameter and large 1.4" outside diameter. Add O-ring or rubber washer to seal onto can. Clamp on a 5/8" hose with a hose clamp and your done. You can print the plug for the other end of the hose.
Gas Can Part by RJR is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving RJR a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure RJR would love to see what you've printed. Please document your print and share a Make with the community.