Picture frame 4 in x 6 in landscape
by berserkerscientist, published
This is a 6" wide x 4" tall (102mm x 153mm) picture frame. It has a built in stand, and a slide-in back plate, to keep the picture in.
I used 10% infill and 0.27 mm layer height and it took about 1 hour for each part (accelerated). I use 230F nozzle and 110F bed temperature. Careful, the frame back can stick to the kapton tape. I tried with a bridge but it was almost impossible to remove.
The frame back is 0.5mm smaller than the front, so it slides in pretty good.
I plan to modify it slightly so the back has a ridge to slide down all the way. Right now, the frame back is supported on the front at the top and bottom. (Also, I'll take a better picture of the frame.)
Liked ByView All
Give a Shout Out
Picture frame 4 in x 6 in landscape by berserkerscientist is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving berserkerscientist a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure berserkerscientist would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).