Replicator 2 replacement feet
by Jigsawnz, published
This is my version of http://www.thingiverse.com/thing:57650
I liked the idea but I found it to much trouble to source 8 screws for something basic as replacement feet. Second, I had 40mm round felt pads already lying around at home so why not use them.
If you print this, please click the "I made one" on this thingiverse page.
Liked Byview all
Give a Shout Out
I printed this:
infill: 100% Layer Height: 0.25mm Shells: 0 Feedrate: 100 Travel feedrate: 150 Temperature: 230
Print four of these. Stick the 40mm round felt pads on them and put them on your makerbot replicator 2.