Minimalist wallet

by RatInDaHat, published

Minimalist wallet by RatInDaHat Mar 7, 2013

Thing Info

3335Views 595Downloads Found in Accessories
Report Thing


A relatively slim wallet for your everyday carry


Well, i wanted a slim wallet. The few on the market that i was very interested in aren't for sale yet. So here is my attempt at designing my own.

I printed at .25mm layer height, 30% infill, 3 perimeters.

print the parts, clean up the groves, etc. put together. I used -128 orings. You need to stretch the orings a bit to get them into the grooves. The design of the walls is undercut so that the orings will retain themselves. I used a 7/64 in ream to clean up the grooves after printing.

The render shows 13 CC's

Any comments, sugegstions, etc, let me know.


Update, I included a .zip of the solidworks assembly. The parts might look a little hacked together, because they are. It was a very quick design. The plate is just two configurations of the same part.

Udate 8 Mar 2013,
I lied, i used -128 orings.

More from Accessories

view more

Thing Info

3335Views 595Downloads Found in Accessories
Report Thing

Liked By

View All

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Nice wallet! Where did you get the elastic bands?

i picked up the -128 orings from http://mcmaster.commcmaster.com. You can probably source them quite a few places.