Talk to the Hand

by into3D, published

Talk to the Hand by into3D Mar 7, 2013


Hand mold scan using 3D3 Solutions Scanner

Recent Comments

view all

Looks amazing!

Yep, it's the yellow one in 'I made one'

Cool, do you have a photo?

More from People

view more


Liked By

view all


Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag


1) Flip it
2) Print it
3) Put it on your desk

If someone engages you in a conversation to which you rather NOT be a part of, simply point at the hand and say the following "Talk to the hand".


You must be logged in to post a comment.

66tbirdJZ on May 2, 2013 said:

I had to make a base so I could print the 'hand' because it's wrist is not flat. I made a thin 1.5mm rectangle just big enough to place the hand in. Did it in netfab btw. I exported both files. The thin platform needed to visit Sketchup to get trued to the Z plane. Then I imported both into Makerware. Put both on the platform and lined them up. I then saved as is and opened it in RepG. Sliced with sk50, sailfish r16 defaults, .2mm layer, 1 shell, 10% infill, 235C/110 temps and a 80mm/sec rate. Repeiter told me it would do a major bridge between the 6th and 10th layer (bottom of the hand/wrist). Next time the palm face right-left and not front back. So I paused at Z and trimmed off the bad strands. (Thank you Sailfish) The next layer set it all down and all was good. Three hours late a very nice and detailed hand was done, but it's yellow. Next one will be tan and I'll glue on a hook to hang it from a closed car window.

into3D on May 2, 2013 said:

Cool, do you have a photo?