Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Accessible Wade's for Hobbed Gear
20
Likes
303
Downloads
1727
Views
Published on March 7, 2013
Description
This is a variant of thingiverse.com/thing:20850
It is intended to use a hobbed drive gear like this trinitylabs.com/products/hobbed-pulley
There is a 608 8mm shaft and a 605 5mm shaft version.
It is intended to use a hobbed drive gear like this trinitylabs.com/products/hobbed-pulley
There is a 608 8mm shaft and a 605 5mm shaft version.
Instructions
Assemble like the Accessible Wade's but add the hobbed gear onto the shaft.
Filament path offset towards the Large gear by 1mm to fit hobb.
Hotend mount is for grooveplate. Openscad file is able to be modded for most hotends.
Some things may need to be adjusted depending on your printer. This is intended for .3mm layer height in order for the support to work...if you use a different setting it will need to be changed in the openscad file and recompiled.
A gear ratio adjustment may be required to adjust for the larger hobb diameter. I have been testing with ABS with good results so far.
This is a work in progress...any suggestions are welcome.
Filament path offset towards the Large gear by 1mm to fit hobb.
Hotend mount is for grooveplate. Openscad file is able to be modded for most hotends.
Some things may need to be adjusted depending on your printer. This is intended for .3mm layer height in order for the support to work...if you use a different setting it will need to be changed in the openscad file and recompiled.
A gear ratio adjustment may be required to adjust for the larger hobb diameter. I have been testing with ABS with good results so far.
This is a work in progress...any suggestions are welcome.
License
Accessible Wade's for Hobbed Gear by TrinityLabs is licensed under the Attribution - Share Alike - Creative Commons license.
More from TrinityLabs
More from 3D Printer Extruders
I'm using it in my modified Rostock and works great. Thanks for sharing.