ORCA 0.43 Rod Fix/ Holder
by JackT, published
The two rods at the top of the Orca are fixed with a screw. If you put too much power on the screw, the plastic brakes. Therefore I made this screw to hold the rod.
The parts can be printed without support fillament. It is a good idea to use a 8mm drill first for the hole to clean it. The hole has an angle of 1Â° degree to fix the rod when you put on the cap. I used the original screws to fasten the base. You can use shorter screws if you like.
Liked ByView All
Give a Shout Out
ORCA 0.43 Rod Fix/ Holder by JackT is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving JackT a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure JackT would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).