Thingiverse
3D Printing 3D Printer Accessories

updated for 5mm ID bearing

camstuff
927
Downloads
1557
Views
Published on March 7, 2013

Derived from

Replicator 2 Extruder Upgrade
by whpthomas

Description

I modded these parts to hold a 5mm ID bearing you can easily find at any hobby shop as well I modded it so I could use regular 3M- 6mm pan head screws you can find in any hardware store CHEAP. I also made a complete assembly file of these parts- you can down load a solidworks free viewer here - edrawingsviewer.com/

Instructions

The parts I have are ment to be printed on thier side... I did not enclude the pin as I left it alone as it uses the MakerBot bolt so no need to change it... so you will need to get the pin from whpthomas original part file.
Tags
This Thing has no tags.
Report as inappropriate

You must be logged in to post a comment.

Enough on April 5, 2013 said:

Hey...my friend..U only uploaded a .SLDASM file..but without every part .SLDPRT file....so i can‘t open ur design。。T^T

camstuff on April 5, 2013 said:

ok put up part files - hope this helps

panxinlong7373 on March 21, 2013 said:

good design

chilled35 on March 13, 2013 said:

Are you able to upload the real Solidworks files, rather than those nasty, horrid EASM files, by any chance? :)

camstuff on March 13, 2013 said:

The native solidworks assembly file is there. It was created in SW2012

MarkTecWizard on March 11, 2013 said:

What is the spec and source for the spring.

camstuff on March 12, 2013 said:

well all I did is just walk into my hardware store... looked at the compression springs that had a OD of 9.6mm (3/8") and when compressed I could measure 10mm (3/8" about) and that was it. :) some ppl try to get way to complicated on this stuff - keep it simple.

charlespax on March 8, 2013 said:

Are you going to upload the source SolidWorks file?

camstuff on March 8, 2013 said:

done and done... have fun

Collections

View all
Makerbot stuff
by terenceang
Extruder
by Talkingba
3D Printer - Extruders
by NexusFlux

Remixes

Made

Liked by

View all

License

updated for 5mm ID bearing by camstuff is licensed under the Attribution - Share Alike - Creative Commons license.

More from camstuff

More from 3D Printer Accessories

⇪