Axis Tensioner - X axis
28
Likes
329
Downloads
455
Views
Published on January 30, 2011
Derived from
Axis Tensioner - X axis
by MakerBlock
Description
Had some issues with the original design, being too long so I did a redesign to make it as short as it will go before hitting the pulley and I also beefed it up a bit.
BTW, This is great if you have an older belt that is stretched.
BTW, This is great if you have an older belt that is stretched.
Instructions
Print, mount it, mark where the hole is to be drilled, remove the tensioner, drill hole, reassemble...then tension the belt, but not too tight!
You must be logged in to post a comment.
License
More from Chooch
Yay!