by Ubersaint, published
Recent Commentsview all
I printed this successfully as well and just as phreak said, it was too small. Hindsight being 20/20 I should have read the comments first. Nevertheless, great model, printed flawlessly while my rep2 has been plagued with extruder problems.
I have a grip for my AR-15 that has a battery compartment in it and IMO feels better than this style of grip... I think a derivative might be in the works :D
I printed it successfully, twice.
First off, flip the model over, so the flat side is down, as it always seems to print better with the flattest side down.
Second: The rail slot is too small for my AR-15 A3's quadrail. I measured the gap at around 18-19mm on the model, and my rail is around 21mm. I scaled the model by 10% and it is VERY close to fitting, and can be filed down to fit, 11% scale should be perfect.
ABS @ 230C
120C bed temp
Full support (I used a thick raft, and had to cut it off, but it didn't curl or warp.)
Scale larger by 11% if your rails are like mine. (9.675" YHM Lightweight Specter Quad Rail, Free Float)
I will release a remix of this shortly, with it flipped and scaled
Liked Byview all
Give a Shout Out
You must be logged in to post a comment.