Spring-loaded Replicator 2 Drive Block WingCommander bearing throwback lever
by funkshin, published
A modification to accommodate the bearing from the original mod. If you don't want to buy more bearings and you trust PLA to a smaller diameter bearing post, you are the target demo.
I followed the instructions on the original and have several hours of successful prints w/ this mod. The only hacky part is the ball left at the end of the bearing post. Despite being a chamfer, you get a ball (roofing?). I cut this off and popped the bearing on and sealed the cover by briefly exposing the joint to a preheated nozzle.
Alternately, you could do a psudo filiment change somewhere after 82%, pop the bearing into place then unpause the job and it should build into negative space w/out issue.
Liked ByView All
Give a Shout Out
Spring-loaded Replicator 2 Drive Block WingCommander bearing throwback lever by funkshin is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving funkshin a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure funkshin would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).