Inlaid for the Ultimaker Z-stage
1
Likes
85
Downloads
434
Views
Published on March 9, 2013
Description
An inlaid for the Ultimaker Z-stage.
Instructions
Sliced with Cura 12.12a.
Layer height (mm) = 0.1, Wall thickness (mm) = 0.6, Fill Density (%) = 100.
Other settings are default.
Remark:
Please be careful when placing the inlaid, it fits very tight.
Specific to the "a" and "e" you should be careful.
Layer height (mm) = 0.1, Wall thickness (mm) = 0.6, Fill Density (%) = 100.
Other settings are default.
Remark:
Please be careful when placing the inlaid, it fits very tight.
Specific to the "a" and "e" you should be careful.
License
Inlaid for the Ultimaker Z-stage by TheSeend is licensed under the Attribution - Share Alike - Creative Commons license.
More from TheSeend
More from 3D Printer Accessories
You must be logged in to post a comment.