Rostock Max Wider Filament Spool Extension Kit
by Av8rRC, published
Recent Commentsview all
I was working on a design to do the same thing. I'm glad I found this before I spent too much time on it. I'm printing right now.
@Av8rRC, cassetti here from the boards. Thanks for this extension kit - printing it now on my MAX (I'll post picts when I finish installing). You should probably consider posting the filament guide as a new thing so it has more visibility. It's a very useful upgrade even if you don't need a wider spool holder
Liked Byview all
Give a Shout Out
Longer screws will be needed to use the extensions. 6-32 x 1 1/2" (Qty:8)
If you find the clips hard to remove. You can use a lighter to heat the pull tab and bend it up.
There are two versions of the extension, a single one(you'll need to print two), a pair of them or a set of small spacers. However you want to print them out.
Per Request: Someone wanted a version of the spool rod split down the middle.
You must be logged in to post a comment.