RAMPS Enclosure
22
Likes
651
Downloads
1113
Views
Published on February 3, 2011
Description
This thing is an enclosure for RAMPS 1.1
The 40mm fan pulls air out of the enclosure, and cooling holes are located near the Pololu heatsinks.
The 40mm fan pulls air out of the enclosure, and cooling holes are located near the Pololu heatsinks.
Instructions
Print this in PLA... (I'd love to hear from anyone who manages to do this in ABS.. it shrinks and falls apart at about 1.5 1.5cm line..)
Mount a 40mm Fan in the end pulling air out of the enclosure. I used some hot-glue.
Mount a 40mm Fan in the end pulling air out of the enclosure. I used some hot-glue.
You must be logged in to post a comment.
License
More from araspitfire
I took the ABS challenge. No cigar. The layers started to separate after 2cm or so. I did turn off the heated bed around this time but I don't think it would have matter the higher layers.