Vacuum Bagging Valve
by DariusShekari, published
Recent Commentsview all
I just printed this , but had some issues, so wondering if you might want to give some advice;
1. After I took of the support material I couldn't get the screw to screw on. Could you advice on how you took off your support materials to get the screw to thread?
2. What resolution did you use? I used a dimensions printer to print mine.
3. I could easily remove the support materials from the valve, but the screw cap ;; very difficult, even after using sodium hydroxide to remove support materials. Any advice here?
Thanks in advance!!!
Liked Byview all
Give a Shout Out
You must be logged in to post a comment.