Loading

Arm Jig For Delta-Pi Reprap 3D Printer

by Stuartblarg, published

Arm Jig For Delta-Pi Reprap 3D Printer by Stuartblarg Mar 14, 2013

Description

This a jig that I made up for accurately gluing the arm sections of the Delta-Pi Reprap 3D Printer.

It is made up of layers of 3mm MDF, laser cut to house the pivot sections, with a base part to set the length.

All the layers are held together with 8 1/8"x25mm bolts.

NOTE: In the picture the bottom layers are acrylic but that is not required it was just what material I had laying around.

Recent Comments

view all
You have the perfect alignment holes already at the ends of your rod. Simply cut 2 holes in a piece of material the right distance apart and thread a bolt into it and tighten it down. Then you simply place the printed piece over it.

More from 3D Printer Accessories

view more

Liked By

view all

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Fairly self explanatory, There are 2 layers of the pivot cut-outs on each side attached to 2 layers of base plate.
You have the perfect alignment holes already at the ends of your rod. Simply cut 2 holes in a piece of material the right distance apart and thread a bolt into it and tighten it down. Then you simply place the printed piece over it.
Top