Huxley Fold Beef'd X axis LM6UU mount's
6
Likes
159
Downloads
542
Views
Published on March 14, 2013
Description
X Motor block and idler beefed up for LM6UU with 4mm slots for cable ties.
Not tried yet as busy,but tabs again broke even using Ryhs-jones carrier.
So added tie rap slots n lot more plastic ;)
Also widened channels for belts + widened M5 axis screw hole.
This was total redisgn from measuring original onto Alibre so dont blame me for errors (they happen)
update 12.05.13 Built it n problem with idler side added extra base depth n narrowed z axis hole 0.5mm, ohh added spacer for idler bearing too.. se ver 3
Not tried yet as busy,but tabs again broke even using Ryhs-jones carrier.
So added tie rap slots n lot more plastic ;)
Also widened channels for belts + widened M5 axis screw hole.
This was total redisgn from measuring original onto Alibre so dont blame me for errors (they happen)
update 12.05.13 Built it n problem with idler side added extra base depth n narrowed z axis hole 0.5mm, ohh added spacer for idler bearing too.. se ver 3
Instructions
Print n fit, hopefully will work
You must be logged in to post a comment.
License
Huxley Fold Beef'd X axis LM6UU mount's by natko is licensed under the Creative Commons - GNU GPL license.
More from natko
More from 3D Printer Accessories
Very nice design! I have just finished updating my printer with this x-ends - let's see how the future will be ;-)
Thanks m8
Yep forgot the spacer which you need washers for also I found that the bottom or base thickness is too thin and that my springs for the Z axis sometimes slip through the larger holes.
Good point is no breakages this time for flight uk to ukrain
BTW cool mod I only use alibre so ver impressed to see how you modified my stl's
Cheers