Replicator 2X Indicator Holder
4
Likes
188
Downloads
522
Views
Published on March 15, 2013
Description
Just as the description says. Indicator holder for Replicator 2X
Instructions
Print the file as downloaded. Install indicator onto holder. Uses an M4 x 20 SHCS and a M4 nut that installs into a nut well for holding lug back indicator to holder. Clip holder on right side of extruder gantry as shown in picture.
Tip:
When installing holder, engage lower hook part of clip first then tilt up into position.
Created with Solid Edge. PAR file is included in set.
Tip:
When installing holder, engage lower hook part of clip first then tilt up into position.
Created with Solid Edge. PAR file is included in set.
You must be logged in to post a comment.
License
Replicator 2X Indicator Holder by 1_spike_1 is licensed under the Attribution - Share Alike - Creative Commons license.
More from 3D Printer Accessories
When i'am loading the stl-file into replicatorG040 the part is to small.
I think it may be because it was designed in inches not mm. Try converting it by multiplying x 25.4 or using a 2540% scale factor.