Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!

SD Key Chain

by georgevaccaro, published

SD Key Chain by georgevaccaro Mar 16, 2013

Thing Info

2391Views 564Downloads Found in Electronics
Report Thing


A key chain fob SD card holder. You can configure the dimensions and depth, hole size etc. This is my first model.


By default this is setup to fit 2 SD cards.

There is a "hinge" so to speak that requires either a flexible material, or to use the hot end to make two 90 degree folds. I imagined a simpler design, but it would have required a 180 degree fold that I'm pretty sure would not happen.

I had trouble printing out a similar but solid SD card holder since it required vertical printing which yielded bad results on my printer. Therefore I designed this to be printed horizontally, which prints much nicer, and then for the two sides to be bent up at 90 degrees.

More from Electronics

view more

Thing Info

2391Views 564Downloads Found in Electronics
Report Thing

Liked By

View All



Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

Customizer is the easiest way to take great 3D printable designs and make them your own. Make your OpenSCAD designs infinitely more valuable by empowering the community to customize them.

App Info Launch App
Customizer Thing App

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App