Loading

IKEA PULT Lamp Clip Replacement

by FunbieStudios, published

IKEA PULT Lamp Clip Replacement by FunbieStudios Mar 16, 2013

Thing Info

1676Views 214Downloads Found in Replacement Parts
Report Thing

Summary

Kind of had the bad luck of losing one of the clips on the IKEA PULT Lamp (at least I think that what it is called - http://www.ikea.com/sg/en/catalog/products/90192900/)

So, instead of wrangling with getting a new ceiling lamp or using bent pieces of wires to hold the glass cover (dangerously!) in place, did a quick 3d model of the missing piece based on the existing ones, and got a pretty good enough holder clip again! =)

Now we can lose all the pieces with impunity!

Hope this helps anyone who else who happens to be missing this part! ;)

(PS: A longer writeup of this is over here - http://funbiestudios.com/2013/03/3d-printing-a-replacement-clip-for-the-ikea-pult-ceiling-lamp/)

Instructions

Probably want to print this at 100% infill at High Resolution (0.1mm layer height) - for maximum structural strength of the piece.

Quite a small piece so this won't lengthen the print time by too much

More from Replacement Parts

view more

Thing Info

1676Views 214Downloads Found in Replacement Parts
Report Thing

Liked By

View All

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Thanx! Just what I was looking for! =)

Hope this helps! Just remember to print on your maximum strength settings (e.g.: infill) just to be sure it holds up! ;)

Top