Shower curtain clip
by fuefuefue, published
This holds the bottom of my shower curtain flush against the wall so water doesn't leak off the side of the tub!
The scad and stl are set up to fit a suction cup I had laying around, but you should be able to make it fit any suction cup with the following parameters:
CUP_STEM: the diameter of the neck of the suction cup stem
CUP_FLANGE: the diameter of the head/mushroom cap of the stem
FLATTENED_RAD: the radius of the suction cup when pressed down, mostly just draws the grey circle that makes it easier to fudge the other params :)