Updated Spool Holder
by RScullion, published
Updated spool holder for Repman 3.1. Stops the spool eating the feed line or getting pulled into the printer.
Also takes larger spools and two different internal diameter sizes.
Print two of the spool holders and two of the feet extenders (they are reversible). The feet extenders require support material though it can be broken up and printed as two halves - the cable tie will hold it.
Attach feet to the existing spool holder using a cable tie.
Put spool holders on followed by feet and tighten screw.
Attach spool holder to lower bar and feed filament through front top hole.
Note: It is possible to add additional fixings but I haven't found it necessary. I did add a bit of masking tape to stop it slipping forward.
Liked ByView All
Give a Shout Out
Updated Spool Holder by RScullion is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure RScullion would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).