by cerberus333, published
My second entry for the Develop3D robot design contest. This is inspired by the really silly robots in the 1930's movie serials. My intent was a robot to hold a sign for a business card or a placeholder at a party. I am sure there are lots of similar functions it could be used for.
Recent Commentsview all
Liked Byview all
Give a Shout Out
I printed with 0% infill and 2 shells but had a gap in the top of the torso and a few loose strings on the under carrige. If you don't mind cleaning up like i do with ABS/ acetone mix then 0% fill works well, if you want to use infill it will likely close the gap Look at the pic on the printer to see the gap and the pics holding the card are after a 2 minute cleanup with the goop.