Sliding pin test
by hoonisjunior, published
This is a test for a slideable pin design i made, you slide it through the slot on the block and then it clicks in. It could still use some work however, and if i change it i will re-upload it.
As you may have noticed, the parts are currently at the wrong angle in the images. You will need to print the bottom of the slot facing upwards (hole on the bed), and the pin has to be printed on its side to remain strong. When printed check the small gap in the pin head and remove any excess plastic, and clean out the slot in the block. After that it should work.
Liked ByView All
Give a Shout Out
Sliding pin test by hoonisjunior is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving hoonisjunior a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure hoonisjunior would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).