Phonecone iPhone4 version
40
Likes
1115
Downloads
806
Views
Published on February 12, 2011
This thing was Featured on February 16, 2011
Description
I saw this design: arkwhat.com/17-arkcanary-ii and decided to make my own. The holder.stl fits an iPhone 4 ass, but the parts are separate if you would like to make one to fit your phone's ass.
Video if it in action: youtube.com/watch?v=apK3GMyn45w
Designed and printed at hive76.org/
Video if it in action: youtube.com/watch?v=apK3GMyn45w
Designed and printed at hive76.org/
Instructions
Print both pieces and weld together with Weldon 3.
I found it helpful to use 2 clamps. Clamp the holder to the table and then the cone on top.
I found it helpful to use 2 clamps. Clamp the holder to the table and then the cone on top.
You must be logged in to post a comment.
License
Phonecone iPhone4 version by eagleapex is licensed under the Attribution - Share Alike - Creative Commons license.
More from eagleapex
Prints fine and fits nice but It didn't work for me. I'm thinking it's because the print was not solid enough. The Replicator 2 medium setting is only 10% infill and my guess is that this is not solid enough to contain and direct the sound. I may try it with a more solid infill setting. Has anyone else had similar experience?