Ultimaker Z-Axis Adjuster
by Whoops, published
This version aims to be more strong and durable. 3 mm screw is replaced by a 4 mm, which is screwed into a nut and not in plastic.
Thank you to Maybites for its good design !
Liked Byview all
Give a Shout Out
Look for mounting scheme it is sufficient to itself.
You will need 3 M3 x 10 screws and 3 nuts, One M4 x 40 screws two washers and a locknut. I also attached a STL of a brace for those who have already printed this http://www.thingiverse.com/thing:22819 and did not want to do it again;-)