Ultimaker internal axle end
3
Likes
73
Downloads
339
Views
Published on March 20, 2013
Description
This thing goes in place of the original wooden axle end of the ultimaker inside the body.
It can hold the 2x M3 nuts so it's a lot easier to fix the part (no more need to hold the nut with a twizzer or nut holder).
The hole in the center is also a little wider in order to limit friction on the bearing.
Works great in conjunction with thing 54075 for the outside.
It can hold the 2x M3 nuts so it's a lot easier to fix the part (no more need to hold the nut with a twizzer or nut holder).
The hole in the center is also a little wider in order to limit friction on the bearing.
Works great in conjunction with thing 54075 for the outside.
Instructions
Print with 0.8mm wall 20% infill.
Push 2x original ultimaker M3 nuts. It's a little hard as the opening is really tight and you will need something to push them in.
Push 2x original ultimaker M3 nuts. It's a little hard as the opening is really tight and you will need something to push them in.
You must be logged in to post a comment.
Collections
ultimaker stuff
by JelleAtProtospace
Ultimaker enhancements
by FrancisBeckers
Ultimaker Stuff
by Whoops
License
Ultimaker internal axle end by coyote69 is licensed under the Attribution - Share Alike - Creative Commons license.
More from coyote69
More from 3D Printer Parts
Lot of competition on these caps LOL!
Let me copy/paste my remark from http://www.thingiverse.com/thi... :D
"BTW, you could fully open the rod hole on one side, i.e. make it look like a "C" shape. This way, the parts could be sled in place without the need to remove the rods."
-cheers