Loading

IPad charging base/stand

by Muxlo, published

IPad charging base/stand by Muxlo Mar 20, 2013

Thing Info

2036Views 306Downloads Found in Gadgets
Report Thing

Summary

Base/Stand for charging an IPad.

Instructions

Was made on Rep. 2: Medium, Infill 10, Shells 3, Layer height .2, Temp 225, Speed w/ext. 75, Speed w/trav. 100. Heads up it took 8.5 hours to build.

More from Gadgets

view more

Thing Info

2036Views 306Downloads Found in Gadgets
Report Thing

Liked By

View All

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App

I tried this on my Replicator dual with some default MakerWare setting ( 10% fill, .2 height, speed 90/150, HBP 120). After 12 hours I was 50% complete but the left side had started to curl so I canceled the build. I might try again with the recommended settings. Or might try to slice of the bottom 50% and print the top half and apply glue :-) The design and the print (so far) was excellent.

Top