Loading

Beanie the Transformer

by acrease77, published

Beanie the Transformer by acrease77 Mar 21, 2013

Description

Beanie is a transformer that can turn into a car. He can also launch his head off! Just pull the rack puller and his head flies off, hence the name "Beanie"

Recent Comments

view all
Thats, a great design..have you checkout the G1 transformers wst...their transformers toys, but 1/6 the size of the original and fully transformable..
I started printing the upper arms and the little joint for attaching the forearm is way too tiny and broke right off also the tiny hole near that same joint failed to print because it too is too thin/tiny.
Gosh darn it! It's just barely outside of my print volume. I think the chassis is the only part I can't print at 100%.

More from Model Robots

view more

Liked By

view all

License

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Assembly is simple! The shorter wheels clip to the feet, the bolts (leg clips) clip the feet to the legs, the longer wheels clip the legs to the hips of the main body, the arm joints (bolts with round ends) go through the "shoulders" and the neck joint. Place the gear in before the neck top, with the + facing upward. Snap the arms into the round sections of the arm joints, with the forearms and claws clipping on through the joints. The head goes on the axle piece and the propeller clips on top. To launch, slide the rack pull into the slot, and then pull! To turn into a car, bend his legs all the way up, rotate the arms around, back over his head, and make sure they are flush with the main body. The claws should latch on just above the "ball holder" of the arm, with the propeller fitting in to the circles under the feet. Any questions or concerns, please let me know!

File Name

Downloads

Size

Thats, a great design..have you checkout the G1 transformers wst...their transformers toys, but 1/6 the size of the original and fully transformable..
I started printing the upper arms and the little joint for attaching the forearm is way too tiny and broke right off also the tiny hole near that same joint failed to print because it too is too thin/tiny.
Gosh darn it! It's just barely outside of my print volume. I think the chassis is the only part I can't print at 100%.
the head piece was in the full file, I added it in now so you should be able to print it by itself!
HUGO! definitely has a tough competitor with this 'Transformer' like design, love it! All the best with the competition results today.
Just me or are we missing the actual head piece here?
Top