Loading

YARB! Yet Another Ramps Box

by paenian, published

YARB! Yet Another Ramps Box by paenian Mar 21, 2013

Description

A box to hold RAMPS electronics, with space for a Reprapdiscount smart controller and a 60mm fan.

I was looking for a minimal box with a good fan mount, but couldn't find anything that fit with all the wires and cables. I've uploaded some pics of the thing wired up - it works! Fan is a tight fit over the wires, but it's supposed to be.

Make sure you route your wires around the pololu heatsinks.

I was thinking about adding a set of zip tie holes on the front edge for wiring, but it's installed now and I don't want to unplug and replug everything.

More from 3D Printer Accessories

view more

Liked By

view all

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Print! The clips holding the arduino in are stiff, but the box is open so you can access all the wiring, so you should only need to insert it once.

The fan is held on by zip ties, arduino clips in. The bolt tabs are 4mm.

Scad is included if you want to edit it. This was made for (and attached to) my Rostock clone. Source for the whole machine is up on github.com/paenian/Rostock-Redux

Comments

You must be logged in to post a comment.

Top