F-22 Fighter Jet Wall Hang
by Peoples-Exchange, published
F-22 Fighter Jet with a Sliced rear so that it can be printed vertically and then mounted to a flat surface. Planning to do a few of these at different angles to create a 3D Airshow on my wall. I used velcro on the back so i could rearrange it if desired.
This was derived from this F-22 model: http://www.thingiverse.com/thing:63453 by IIIWhiteBoyIII
Layer Height: .15
Dimensions: 149mm x 145mm x 45mm (~5.75" x 5.5" x 1.5")
Build Time: 4hrs 42min
Liked ByView All
Give a Shout Out
F-22 Fighter Jet Wall Hang by Peoples-Exchange is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure Peoples-Exchange would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).