Replicator 2 build plate fan mount
by bluejay117, published
I overheated my Replicator 2 aluminum heat sink one day and messed up my original fan mount. This one has a higher horizontal part to allow for more room for the spring loaded filament loaders, as well as holes to allow access to the fan mount screws from above. The two small rectangular parts in the cable bundle attachment point snap off. The piece across the diameter is meant to help hold the fan cable and the small overhang in the cable groove allows for better capture of the thermocouple and heater wires.
Recent Commentsview all
What print settings did you use under Makerware? Won't the portion touching the hot plate with the two screws melt?
Beautiful. Much appreciated. 24 hours on this and I love it. Addressing that poor little thermocouple cable was a nice touch.
Liked Byview all
Give a Shout Out
Break off strip in cable bundle channel (channel on top of part)
Added solidworks file
You must be logged in to post a comment.