Thingiverse

RAMPS mount for Prusa Mendel

wilson
1538
Downloads
1813
Views
Published on February 21, 2011

Description

This things will keep your RAMPS from flopping around until you get a proper enclosure printed. It clamps onto the bottom threaded rod of the frame and will fit 5/16" or m8. It also includes two little brackets for mounting a fan above the board to keep your pololus cool.

Instructions

Print the pieces and assemble with m3 screws.
Tags
This Thing has no tags.
Report as inappropriate

You must be logged in to post a comment.

blddk on December 4, 2011 said:

I don't know if you know, but some time ago I added the function to sprinter, that can turn a fan on and off. :)

All needed to be done is to give it the pin on which the fan is connected to, and it will then turn the fan on when any stepper driver is enabled, and wait a defined time after all drivers are turned off again, before turning the fan off. :)

Wrote a bit about it here: http://captain-slow.dk/2011/
10/16/cool-stepper-drivers/

shadowmite on November 14, 2011 said:

So I printed this and am trying to figure out how to use it but the mounting holes for the ramps board don't line up with the standoff's up on the one next to the power connector... did the ramps layout change?

Collections

View all
Things to Make
by darrylf42
Mendel Prusa i2 upgrades
by smellymoo
Things to Make
by poppen03

Remixes

Made

View all

Liked by

View all
Image

License

Public Domain
RAMPS mount for Prusa Mendel by wilson is licensed under the Public Domain license.

More from wilson

⇪