Single Switch Mount
by jawoo2006, published
I went to RadioShack and found a package of switches that had a nice click to them. All of them were expensive for a single one until I found one that would work for exactly what I needed. There was a slight notch in the hole so the switch stays in place.
The one I found at my local RadoShack was this http://www.radioshack.com/product/index.jsp?productId=12688419 except it was a double pack for mounting in a vehicle.
I used PLA at 30% infill. There might some slight post processing of shaving the hole for it to fit the switch.
Liked ByView All
Give a Shout Out
Single Switch Mount by jawoo2006 is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure jawoo2006 would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).