Short Guard for Oster 76

by ZeeMan, published

Short Guard for Oster 76 by ZeeMan Mar 29, 2013

Thing Info

2536Views 621Downloads Found in Household
Report Thing


This a shorter version of the 3/8 inch hair clippers guard! For short hair but not bald!
It's just a shorter one of this thing: http://www.thingiverse.com/thing:34788 which is 3/8 inch.


Print this little fellow out, attach it to your very own Oster 76 hair trimmers and get to work!

Infill: 10-15. DO NOT exceed 40% other wise it will peel up due to cooling. even 30% may be to much.
Shells:1. Any more and you will have to file the edges to make it fit.
No raft. It makes the underside rough.

I don't know the height on this guy but he's short! I rounded the edges like I did on the 3/8 inch guard v4.5 for the best comfort. I'd like to someday make the measurements for all of the sizes and have my very own set of printable clipper guards! Enjoy!

More from Household

view more

Thing Info

2536Views 621Downloads Found in Household
Report Thing

Liked By

View All


Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App

Hello ZeeMan,
I like what you have done, just wish I could print it out. Slicer complains about a hole near the edge.... Any chance you encountered the same error when you printed yours? Sorry if this is a noob question. I am using Slicer on my Printrbot LC.
Thanks in advance,

Brilliant! I have an old Oster clipper and one of the guards I used to use a lot had the clip on one side break so I had to resort to electrical tape. I wonder if it was my 3/8" guard.

Let me know if there is a size you would like! I do need to clean up the front as well to make it more comfortable still. I'm really happy you like it! :)