Asian Lantern (2)

by Keenan, published

Asian Lantern (2) by Keenan Mar 30, 2013

Thing Info

15361Views 4064Downloads Found in Decor
Report Thing


Decorative two piece Asian inspired lantern with geometric design. Different variant of my other lantern. Designed to print without support.


Print out both pieces. Designed to work without support.

-The bottom would look great with .25mm layers, 2 perimeters and low infill. Because of its shallow slope, the top would work better with under .25mm layers, 3 perimeters and low infill.
-The columns of the geometric design can get sheared off by the nozzle, especially at smaller scales, and especially if your slicer does the perimeters first and then comes back to infill them solid. I had to revise the design several times to make them stronger.
-The top is supposed to snap onto the base, but you may have to scrape some plastic away once printed to get the proper clearances.
-Check out the attached sketchup file. The geometric design is its own component and can be edited independently. Changing just one panel will update all 6 automatically.
-The STLs were processed through netfabb so should be error free. Check out http://cloud.netfabb.com/

More from Decor

view more

Thing Info

15361Views 4064Downloads Found in Decor
Report Thing

Liked By

View All


Asian Lantern (2) by Keenan is licensed under the Creative Commons - Attribution license.

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App