Round Inkwell

by samkass, published

Round Inkwell by samkass Mar 30, 2013

Thing Info

2039Views 511Downloads Found in Office
Report Thing


This is a small round inkwell appropriate for holding a small amount of ink, or decoratively holding a quill on a desk.


The pictured inkwell was built on a Replicator 2 using MakerWare with a 0.2 layer height, 2 shells, and 25% infill. It is pretty much water-tight as long as you have a reliable extruder (see http://www.thingiverse.com/thing:53125 to correct the Replicator 2's extruder design flaw) and at least two shells.

It uses gradual angles at the base then all 45 degree angles internally and at the top, so it should build fine with no supports. The bottom center is flat so it shouldn't need rafts either.

More from Office

view more

Thing Info

2039Views 511Downloads Found in Office
Report Thing


Liked By

View All


Round Inkwell by samkass is licensed under the Creative Commons - Attribution license.

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App

Kiri:Moto is an integrated cloud-based slicer and tool-path generator for 3D Printing, CAM / CNC and Laser cutting. *** 3D printing mode provides model slicing and GCode output using built-in...

App Info Launch App
KiriMoto Thing App