by mikedeklerk, published
A fantasy car. Not based on any car. The design is made up. Its can ride.
Liked Byview all
Give a Shout Out
Print high poly model + 4 tires. Screw tires on model with 2.5mm screws. Do not tighten them to much so the wheels can rotate. Use a 2mm drill if the pre-printed screw holes are too tight. Or add some liquid ABS or glue if the wholes are too wide. You should drill the holes in the wheels with 2.5mm for a good fit, as they will be printed just to small for a 2.5mm screw on purpose.