Ball and Socket Tri-Connector
by Vivenda, published
NOTE: This thing isn't designed to be printed in ABS/PLA. The tolerance in the pieces don't allow them to fit into each other. A socket printed in Nylon will fit on the ball. A ball joint printed in Nylon may potentially get stuck or break in a socket printed in ABS/PLA (if it fits).
Recent Commentsview all
Hey perlguy, I printed these at 247C (though the readings fluctuated between 245-257 throughout).
I don't have a heated bed. I printed these on a glass plate with blue tape and a thin layer of UHU glue spread for better adhesion. I know there's better ways which I'm still investigating such as a garolite plate or other adhesives.
Liked Byview all
Give a Shout Out
0.2 Layer Height
You must be logged in to post a comment.