Top Shot Elite replacement Stock
by kingtut, published
When I bought a second hand Top Shot Elite gun, it didn't come with a stock. So I made one.
Note that both pieces are quite long - verify that they'll fit on your printer. Both (just) fit and worked on an Ultimaker.
Print both (a) and (b) parts - (b) should slide smoothly onto (a). If there isn't enough friction, drill a hole ~2 cm along (b) on the left hand side (i.e. the side with the serrations on (a)) and insert a screw or similar. When printing (a), you need to print with a high fill ratio (I used 100%) as otherwise it will likely fail where the narrow and wider parts meet.
Liked ByView All
Give a Shout Out
Top Shot Elite replacement Stock by kingtut is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving kingtut a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure kingtut would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).