Light Switch Lock
by Yllonnoce, published
You need to print with support there is a detail the has a cut away to clear the switch area.
I also included the CREO .pk2
Recent Commentsview all
If you put little blocks under the piece that needs to be supported, you can basically not require users turn on support material for their slicer. Take a look at this to get an idea of the modifications needed: http://www.thingiverse.com/thi...
I'm using two to replace the 10 year old packing tape on the two switches that turn off the outlet to my entertainment center. I feel like the lock lever should be a bit longer because it gives the switch a bit more wiggle room than I'd like and it might be enough to break the circuit. I'll have to test one on a light or something. Either way it is still a good visual indicator.
Liked Byview all
Give a Shout Out
You must be logged in to post a comment.