OrdBot Z Block
by davr, published
Use This Project
Give a Shout Out
This is a fix for the two z axis threaded rods on an ordbot binding up. Unless they are perfectly aligned, as the axis travels up and down it can bind up causing skipped steps and ruined prints.
Unscrew the metal block from the frame, and screw this block instead. The threaded rod threads onto the metal block, which sits below the printed part, with its too-big hole. This allows the threaded rod to wobble around without binding up. I believe it will introduce a small amount of backlash into the z-axis, but that's better than binding up and skipping steps.
OrdBot Z Block by davr is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
Show Some Love
Say thanks by giving davr a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure davr would love to see what you've printed. Please document your print and share a Make with the community.